This is the mail archive of the
gdb@sourceware.org
mailing list for the GDB project.
Re: debugging gdb using gdb
- From: paawan oza <paawan1982 at yahoo dot com>
- To: "gdb at sourceware dot org" <gdb at sourceware dot org>, Michael Snyder <msnyder at vmware dot com>
- Date: Fri, 18 Feb 2011 20:51:01 -0800 (PST)
- Subject: Re: debugging gdb using gdb
can I get some inputs regarding following mail chain ?
as debugging gdb using gdb on arm is becoming difficult.
Regards,
Oza.
----- Original Message ----
From: paawan oza <paawan1982@yahoo.com>
To: Michael Snyder <msnyder@vmware.com>
Cc: "gdb@sourceware.org" <gdb@sourceware.org>
Sent: Thu, February 17, 2011 9:01:12 AM
Subject: Re: debugging gdb using gdb
it works absolutely fine on x86 linux.
on both terminals gdb allows input output at any time.
the difference is;
in arm-linux I connect through telnet
while in x86-linux, just local native terminal.
Regards,
Oza.
----- Original Message ----
From: Michael Snyder <msnyder@vmware.com>
To: paawan oza <paawan1982@yahoo.com>
Cc: "gdb@sourceware.org" <gdb@sourceware.org>
Sent: Wed, February 16, 2011 11:38:25 PM
Subject: Re: debugging gdb using gdb
paawan oza wrote:
> Hi,
>
> during reversible implementation, I am trying to debug arm-gdb using arm-gdb.
> so i connect through telnet terminal and open two different terminals.
> and run both the gdb on target and attach the one gdb with another one.
> the moment I attach another gdb and give continue command, the gdb being
>debugged, looses iis terminal, and I am not able to type anything, and gdb does
>not accept any keyboard input and it hangs.
>
> Regards,
> Oza.
What happens if you try the same thing on x86 linux?