This is the mail archive of the
gdb@sources.redhat.com
mailing list for the GDB project.
Re: help with remote debug!!
chester@linux.org.tw wrote:
>
> Hi....!
> I got some confuse about remote debug feature on gdb.
> (I have read some GDB doc).
> Build all of cross-compile in my PC for StrongARM and bootable
> kernel that uses cross-compile.
> Then i do the following command,
From memory, adding the GDB stub to the Linux kernel was only a recent
inovation. I guess, the kernel stub code is enabled and is known to
work. Does that stub code come with a Linux HOWTO tht is specific to
the arm?
> $ arm-unknown-linux-gdb vmlinux
>
> and,
> (gdb) set remotebaud 115200
> (gdb) target remote /dev/ttyS0
Ok so far. (should I also mention set debug remote ...? :-)
> (gdb) run
this looks wrong. If I assume that you've set up:
<gdb vmlinux> - /dev/ttyS0 ------ arm board with kernel
then I don't know that ``run'' is applicable.
One guess of what should happen is:
o the arm board boots the kernel
o the arm board traps to the
sub
o you connect gdb to the serial
line connected to the arm board
o after entering ``target remote...''
you can examine the kernel state
o use continue (not run) to resume
execution
Andrew
>
> But it hang on connect to remote target,no message on my terminal.
>
> What can i do for it ?? Or more doc i can study??
>
> Thanks,
> Chester