This is the mail archive of the gdb@sourceware.cygnus.com mailing list for the GDB project. See the GDB home page for more information.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
Thank you very much. It worked as you said. best regards, Bumsoo Kim kbs@swc.sec.samsung.co.kr > -----Original Message----- > From: fortinj@ibm.net [SMTP:fortinj@ibm.net] > Sent: Monday, April 12, 1999 9:18 PM > To: PARK JONG PORK $)C > Cc: !>e)vu(yo; gdb@cygnus.com > Subject: Re: how to build gdb with cygnus? > > What I did is went into each directory individually and ran configure. > Some of them didn't work correctly, some of them did. I then copied the > largest config.cache without errors to the base directory and ran > configure again. I believe I had one or two small errors, but ignored > them. I checked the config.cache after the errors and the correct > values were there. I don't remember which they were. > > gdb then compiled, though without thread support. > > regards, > John Fortin > fortinj@ibm.net > > PARK JONG PORK wrote: > > > > I had same problem. > > and, new snapshot(04/xx) can't compile Perl 5.005_03 better. > > > > ----- "/)*(,!m ",(-(vAAo ----- > > (,",)x(v !mc"R!@: !>e)vu(yo <kbs@swc.sec.samsung.co.kr> > > )v(-"%A !mc"R!@: <gdb@cygnus.com> > > (,",)x(v )x?A!M: 1999)xa 4"/u 12AI "/u"/aAI "/AEA 3:46 > > A|",n: how to build gdb with cygnus? > > > > > John Fortin told us: > > > > > > > All, I compiled the newest snapshot of gdb using cygwin ( after > > > fighting > > > > with the configuration. Doesn't seem to work well recursively. ) > > > > > > I have the same problem with gdb-4.17 and gdb-4.18. > > > Could you tell me how you worked it out? > > > > > > Thanks, > > > Bumsoo Kim > > > kbs@swc.sec.samsung.co.kr > > > > > >