Re: [commit/cris] Add guru mode setting for CRISv32

[Orjan Friberg <orjan dot friberg at axis dot com>]

Eli Zaretskii wrote:
> Thanks.
>
> These patches introduced new user-level commands, but didn't include
> any documentation for them, neither in the command's built-in
> documentation nor in the manual.  Please in the future _always_
> accompany user-level changes with a suitable documentation changes.

I'm sorry; I hadn't even realized there was a CRIS section in the manual.

Ok to commit?

2005-05-13  Orjan Friberg  <orjanf@axis.com>

	* gdb.texinfo (CRIS): Update the cris-version and cris-dwarf2-cfi
	documentation.  Add documentation for cris-mode.

(I will be gone for most of next week and will be unresponsive at best during 
that time.)

--
Orjan Friberg
Axis Communications

Index: gdb.texinfo
===================================================================
RCS file: /cvs/src/src/gdb/doc/gdb.texinfo,v
retrieving revision 1.253
diff -u -r1.253 gdb.texinfo
--- gdb.texinfo	12 May 2005 09:05:42 -0000	1.253
+++ gdb.texinfo	13 May 2005 15:03:53 -0000
@@ -14665,23 +14665,32 @@
 @table @code
 @item set cris-version @var{ver}
 @cindex CRIS version
-Set the current CRIS version to @var{ver}.  The CRIS version affects
-register names and sizes.  This command is useful in case
-autodetection of the CRIS version fails.
+Set the current CRIS version to @var{ver}, either @samp{10} or @samp{32}.
+The CRIS version affects register names and sizes.  This command is useful in
+case autodetection of the CRIS version fails.
 
 @item show cris-version
 Show the current CRIS version.
 
 @item set cris-dwarf2-cfi
 @cindex DWARF-2 CFI and CRIS
-Set the usage of DWARF-2 CFI for CRIS debugging.  The default is off
-if using @code{gcc-cris} whose version is below @code{R59}, otherwise
-on.
+Set the usage of DWARF-2 CFI for CRIS debugging.  The default is @samp{on}.
+Change to @samp{off} when using @code{gcc-cris} whose version is below 
+@code{R59}.
 
 @item show cris-dwarf2-cfi
 Show the current state of using DWARF-2 CFI.
 @end table
 
+@item set cris-mode @var{mode}
+@cindex CRIS mode
+Set the current CRIS mode to @var{mode}.  It should only be changed when
+debugging in guru mode, in which case it should be set to 
+@samp{CRIS_MODE_GURU} (the default is @samp{CRIS_MODE_NORMAL}).
+
+@item show cris-mode
+Show the current CRIS mode.
+
 @node Super-H
 @subsection Renesas Super-H
 @cindex Super-H