This is the mail archive of the
ecos-patches@sources.redhat.com
mailing list for the eCos project.
Re: MPC860: quicc_smc_serial_driver change
- From: nprasad3 at gmu dot edu
- To: Gary Thomas <gary at mlbassoc dot com>
- Cc: eCos patches <ecos-patches at ecos dot sourceware dot org>
- Date: Thu, 08 Jan 2004 12:52:00 -0500
- Subject: Re: MPC860: quicc_smc_serial_driver change
Gary,
That was it!, disabling the I/O startup messages, the diag and interrupt serial driver co-exist. Output is the same as the last one except Init messages are not present.
Polling mode would help take care of the startup I/O messages also.
Thanks
Nirmal
----- Original Message -----
From: Gary Thomas <gary@mlbassoc.com>
Date: Thursday, January 8, 2004 12:43 pm
Subject: Re: MPC860: quicc_smc_serial_driver change
> On Thu, 2004-01-08 at 10:38, nprasad3@gmu.edu wrote:
> > Gary,
> >
> > I am attaching the output from 3 different runs on my platform
> of the same
> > tester. I had used the mbx port as a starting point but looks
> like the diag
> > and interrupt driver do not like each other.
>
> Can you try it *without* the I/O initialization messages turned
> on?
> I've seen troubles with that before.
>
> --
> Gary Thomas <gary@mlbassoc.com>
> MLB Associates
>
>
>