This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
ecos for STM32F4-discovery problem
- From: tangwei <tziang at hotmail dot com>
- To: <ecos-discuss at ecos dot sourceware dot org>
- Date: Mon, 24 Dec 2012 16:45:31 +0800
- Subject: [ECOS] ecos for STM32F4-discovery problem
- References: <20121101140156.9515@web002.roc2.bluetie.com>,<BAY163-W48F5C6EABDFE0330D72287C0680@phx.gbl>
Dear all,
I use the hal_stm32x0_led(char c) debug,and found
it have trouble in stm32_misc.c 's hal_variant_init() , hal_stm32x0_led(3) run OK,hal_stm32x0_led(7) failed
void hal_variant_init( void )
{
#if 1 //!defined(CYG_HAL_STARTUP_RAM)
hal_start_clocks();
#endif
// Attach EXTI springboard to interrupt vectors
HAL_INTERRUPT_ATTACH( CYGNUM_HAL_INTERRUPT_EXTI9_5, hal_exti_isr, 0, 0 );
HAL_INTERRUPT_ATTACH( CYGNUM_HAL_INTERRUPT_EXTI15_10, hal_exti_isr, 0, 0 );
#ifdef CYGSEM_HAL_VIRTUAL_VECTOR_SUPPORT
hal_stm32x0_led(3);
hal_if_init();
hal_stm32x0_led(7);
#endif
}
I think it is caused by the difference between STM32F407IGH6 and STM32F407VGT6 , does anyone have an idea?
----------------------------------------
> From: tziang@hotmail.com
> To: ecos-discuss@ecos.sourceware.org
> Subject: ecos for STM32F4-discovery problem
> Date: Fri, 9 Nov 2012 17:32:16 +0800
>
>
>
> Dear all,
>
> I have a board named STM32F4-Discovery(STM32F407VGT6) which is similar as the STM3240G-EVAL(STM32F407IGH6) board,
>
> I use the redboot setting for the EVAL board,use the ROMINT start-up,
>
> then download the redboot.bin into flash start from 0x08000000, but the UART4(pc10-TX,pc11-RX) have nothing output,
>
> can anyone give me some help,thanks.
>
> BTW, I change the clock setting from 25MHz to 8MHz,because the discovery board use 8MHz.
>
> thanks.
>
> -----------------
> tangw
>
>
>
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss