This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
which address of FLASH should at91sam7s redboot burn to ?
- From: wb ning <helloningwb at gmail dot com>
- To: ecos-discuss at ecos dot sourceware dot org
- Date: Thu, 18 Jun 2009 14:37:45 +0800
- Subject: [ECOS] which address of FLASH should at91sam7s redboot burn to ?
hello, everyone, i downloaded the Prebuilt RedBoot binaries for Atmel
AT91SAM7S. But After i burn the redboot_rom.bin into at91sam7s256's
flash at address 0x100000, it can't startup when power on. The
datasheet said 0x100000 is the beginning address of Flash. So i burn
it there. I use the readelf command to find the redboot_rom.elf say
its entry point is 0x100040, But when i burn redboot_rom.bin there, it
can't startup either. Can you tell me where should i burn the
redboot_rom.bin, since the redboot_rom.elf is too large to burn.
Thanks.
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss