Re: [ECOS] i386 FAT HDD support

[Andrew Lunn <andrew at lunn dot ch>]

On Mon, Nov 07, 2005 at 01:52:03PM -0500, Scott Bailie wrote:
> Using the command line configtool as you indicated works perfectly. 
> 
> I still can not mount the drive, however. I enabled debug statements in
> ide_disk.c and I get indication that a device was found - it displays the
> Serial, Firmware Rev, Model, etc. but then I see the following message -
> "IDE device 0:0 is not a hard disk!"  When the device is identified the
> "kind" is "c". According to ide_disk.c it should be "2". I tried another HDD
> but I get the same behavior. Suggestions?

See the thread at:

http://sources.redhat.com/ml/ecos-patches/2005-02/msg00002.html

It looks like its time to commit the second part of the patch, but in
a cleaned up state.

        Andrew

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss