This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
EXCALIBUR_REGS_PHYS_BASE??
- From: yrodguez at iuma dot ulpgc dot es
- To: ecos-discuss at sources dot redhat dot com
- Date: Wed, 18 May 2005 10:49:54 +0100
- Subject: [ECOS] EXCALIBUR_REGS_PHYS_BASE??
hi,
I`m a newbie with ecos and i'm trying to port ecos to Integrator CM922t-XA10
board. This board has an Altera Excalibur Stripe EPXA 10 ARM based embedded
processor PLD. The excalibur board has the same stripe. I want to use the
excalibur template as a baseline.
The stripe has a register bank mapped on bus, and the base address is
configurable. In include/excalibur.h define this base address:
#define EXCALIBUR_BASE EXCALIBUR_REGS_PHYS_BASE
but, i don`t find where EXCALIBUR_REGS_PHYS_BASE is defined.
also there is an include:
#include <pkgconf/hal_arm_arm9_excalibur.h>
but , i don`t find this file
any idea???
thanks
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss