This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Pb to start application with GDB
- From: alix t <talix1603 at yahoo dot fr>
- To: ecos-discuss at sources dot redhat dot com
- Date: Fri, 12 Dec 2003 14:13:37 +0100 (CET)
- Subject: [ECOS] Pb to start application with GDB
Hi,
I'm developping an application RedBoot-Ecos for a new
motorola evaluation board with powerpc MPC8275.
I have developped a RedBoot in ROMRAM startup mode.
I have problems to start an application with GDB. When
I use continue command, application never start ....
The only way to start the application is to use the
following commands, nexti + jump *start_address. Any
suggestion?
Behavior with Cont command:
(gdb) set remotebaud 38400
(gdb) target remote com1
Remote debugging using com1
0x0000ece4 in ?? ()
(gdb) load
Loading section .text, size 0x7860 lma 0x51000
Loading section .rodata, size 0x9ec lma 0x58860
Loading section .data, size 0x538 lma 0x59250
Start address 0x51000, load size 34692
Transfer rate: 27753 bits/sec, 502 bytes/write.
(gdb) cont
Continuing.
Behavior with nexti + jump command:
(gdb) set remotebaud 38400
(gdb) target remote com1
Remote debugging using com1
0x0000ece4 in ?? ()
(gdb) load
Loading section .text, size 0x7860 lma 0x51000
Loading section .rodata, size 0x9ec lma 0x58860
Loading section .data, size 0x538 lma 0x59250
Start address 0x51000, load size 34692
Transfer rate: 30837 bits/sec, 502 bytes/write.
(gdb) nexti
[New Thread 1]
0x00015e24 in ?? ()
(gdb) jump *0x51000
Continuing at 0x51000.
Hello, eCos world!
Regards,
Alix
_________________________________________________________________
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
Yahoo! Mail : http://fr.mail.yahoo.com
--
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss