[ECOS] e7t serial port application help needed

[F dot T dot Nilsson at hw dot ac dot uk]

Hi all,

I am developing a simple application to run on arm e7t board. I want to use 
com0 on the board to detect incoming data to the board and com1 to send 
data back to computer. As I built the e7t I found two serial io header 
files in my pkgconf: io_serial_arm_e7t.h and io_serial.h which one should I 
use for developing my application?

Any help is appreciated.

If anyone out there have developed some simple serial application and have 
sample code that they would share would be much appreciated.

         ---------------------------------------------------
            --------------- F R E D D A N---------------
                ------------------------------------
                      ------------------------
________________________________________________________________

DISCLAIMER:

This e-mail and any files transmitted with it are confidential
and intended solely for the use of the individual or entity to
whom it is addressed.  If you are not the intended recipient
you are prohibited from using any of the information contained
in this e-mail.  In such a case, please destroy all copies in
your possession and notify the sender by reply e-mail.  Heriot
Watt University does not accept liability or responsibility
for changes made to this e-mail after it was sent, or for
viruses transmitted through this e-mail.  Opinions, comments,
conclusions and other information in this e-mail that do not
relate to the official business of Heriot Watt University are
not endorsed by it.
________________________________________________________________

-- 
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss