hi! thanks for the reply...
i was trying to perform the ping test using the ping_test test
file,it outputs ok after i downloaded the program and run it using
arm-elf-gdb. However, i can not ping the ip address i assigned for the
StrongArm target after i change is in net.cdl....what could possibly
went wrong?can you send me e exact procedure of configuring the
net.cdl.
thanks!
-------Original Message-------
Date: Monday, November
11, 2002 07:37:52 PM
Subject: Re: [ECOS]
TCP/IP stack testing problem for ecos
hi,
Before doing ping test u have to assign the
ip addresse,netmask, server address & gateway address to your
stack .It could be done by two ways ...one by mannually assigning the
adressess or by using Bootp Or
DHCP.These options can be set in net
cdl. Have a look of nel.cdl file . if u want to build it mannuall u
have to keep other options (BOOYP ,DHCP) desabled. Accordingly set
other options to appropiate value (like ip addresses..). then run
build the whole template again & run the ping test .if u find any
problem in it replay the same i ll give u the details procedure of
doing it.
|