This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: RE: error connecting to GDB.. (need some more..help)
- To: gthomas at cambridge dot redhat dot com <gthomas at cambridge dot redhat dot com>
- Subject: [ECOS] Re: RE: error connecting to GDB.. (need some more..help)
- From: "Sateesh Soman" <sateesh_soman at rediffmail dot com>
- Date: 3 Jul 2001 13:20:40 -0000
- CC: ecos-discuss at sources dot redhat dot com <ecos-discuss at sources dot redhat dot com>
Hi,
I wasn't able to type the '$' itself. My target doesn't repond after that.
I'll try with slower baud rates and let you know.
Sateesh.
------------- Original Message --------------
Gary Thomas <gthomas@cambridge.redhat.com> wrote:
Subject: RE: error connecting to GDB.. (need some more..help)
On 03-Jul-2001 Sateesh Soman wrote:
> Hi,
> I have a similar problem of connecting to the target through GDB using serial.
.
.
.
.
.
> I am using V2.0.2 ConfigTool with latest eCos package (dt: 28-06-01) and my target is a PC. Host
> is running WinNT. I have built redboot with importing floppy.ecm.
>
Try connecting via hyperterm and typing '$Hc-1#09' by hand. You should get
something like this: +$OK#9a (Note, you won't seen anything until the '+'
comes back). If this works when typed slowly, I would think that your target
can't keep up with data at 38400 when it comes in bursts. If that is the
case, then you could try rebuilding RedBoot for the target to run GDB at a
slower baudrate.
____________________________________________________
Buy Feng Shui Package for Rs. 151/- only, at http://shopping.rediff.com/shopping/fengshui_mailer.htm