This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
RE: MBX860 connect problem
- To: Daniel Lind <daniel dot lind at sth dot frontec dot se>
- Subject: RE: [ECOS] MBX860 connect problem
- From: Gary Thomas <gthomas at redhat dot com>
- Date: Tue, 19 Sep 2000 09:49:00 -0600 (MDT)
- Cc: ecos-discuss at sourceware dot cygnus dot com
On 19-Sep-2000 Daniel Lind wrote:
> Hello!
> I have problem to connect to my target MBX860. I have installed my stub
> into FLASH according to the eCos manual. I have checked that the
> baudrate is correct, 38400. When I'm trying to connect to my target in
> GDB or running the tests in eCos Config I get the message packet error
> continuing... three times ( I guess I'm not the first one).
> After installing the stub into FLASH I have tried to boot using the
> newly programmed stub. Is there any way to se if my target is alive or
> COM1 using hyperterm? I'm using windows NT in combination with MBX860.
Connect to the board at 38400/8N1. You should see a string which starts
with $T immediately after reset.