This is the mail archive of the crossgcc@sources.redhat.com mailing list for the crossgcc project.

See the CrossGCC FAQ for lots more information.

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]
Other format:	[Raw text]

Re: Cross Tools Help

From: Bill Gatliff <bgat at billgatliff dot com>
To: sridhar <nsridhar at igcar dot ernet dot in>
Cc: crossgcc at sources dot redhat dot com
Date: Mon, 5 May 2003 09:21:07 -0500
Subject: Re: Cross Tools Help
References: <20030307085116.A12967@saturn.billgatliff.com> <Pine.SV4.3.93.1030505121132.21934A-100000@eid>
Reply-to: bgat at billgatliff dot com

N. Sridhar:


Ask the crossgcc mailing list, apparently.  :^)


b.g.

On Mon, May 05, 2003 at 12:14:01PM -0500, sridhar wrote:
> Dear Mr.Gatliff,
> 
> 	When i build a m68k-elf cross tool chain, during configure step i
> specify target=m68k-elf and the toolset is built for all families of m68k
> like CPU's 68K, 68020, 68030, 68040, etc.
> 
> 	If i want to build the toolset for a particular CPU only (say
> 68020), how do i do it?
> 
> Regards,
> 
> N.SRIDHAR
> Electronics & Instrumentation Divn
> Indira Gandhi Centre For Atomic Research (Dept. of Atomic Energy)
> Kalpakkam - 603102 
> 
> 
> 
-- 
Bill Gatliff
Embedded Linux development and training services.
http://billgatliff.com

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sources.redhat.com

References:
- Re: Cross Tools Help
  - From: sridhar

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]