This is the mail archive of the
sid@sourceware.org
mailing list for the SID project.
FW: run sid problem
- From: "Robert Cragie" <rcc at jennic dot com>
- To: "SID" <sid at sources dot redhat dot com>
- Date: Fri, 21 Oct 2005 16:01:00 +0100
- Subject: FW: run sid problem
In plaintext...
-----Original Message-----
From: Robert Cragie [mailto:rcc@jennic.com]
Sent: 21 October 2005 15:59
To: ganesh koti
Cc: sid@sources.redhat.com
Subject: RE: run sid problem
It looks like for some reason the SID Tk component was not built. Do you
have Tcl/Tk installed on your system? If not, you will need to install it to
use the Tk monitor windows which SID can use.
I should point out it has been a long time since I have done this and SID
may have moved on since the original article, so I have forwarded this to
the SID mailing list - the people on there are very knowledgeable and
normally very helpful.
Robert Cragie, Design Engineer
_______________________________________________________________
Jennic Ltd, Furnival Street, Sheffield, S1 4QT, UK
http://www.jennic.com Tel: +44 (0) 114 281 2655
_______________________________________________________________
-----Original Message-----
From: ganesh koti [mailto:kr.ganesh@rediffmail.com]
Sent: 21 October 2005 15:33
To: rcc@jennic.com
Subject: run sid problem
dear sir,
I build the SID as given in http://www.asisi.co.uk/ecos_sid.html page.
when i run SID as:
# arm-elf-sid --board=pid7t-normalmap --gdb=2000 -EL --tksm &
it gave the following error:
[root@bhatbhahd /]# /tmp/sid-22103.conf:50: component type sid-control-tksm
unknown
/tmp/sid-22103.conf:141: component tksm not found
/tmp/sid-22103.conf:145: component tksm not found
/tmp/sid-22103.conf:156: component tksm not found
plz tell me what might be the problem.
regards,
Ganesh.K.R