This is the mail archive of the
newlib@sources.redhat.com
mailing list for the newlib project.
err configuring newlib for powerpc-linux
- From: "Anandapadmanabhan,Ramanathan" <Ramanathan dot Anandapadmanabhan at wipro dot com>
- To: newlib at sources dot redhat dot com
- Date: Wed, 4 Jun 2003 10:26:11 +0530
- Subject: err configuring newlib for powerpc-linux
Hi All,
I am trying to setup an cross development envrn. for powerpc-linux on
i686-linux.
Built binutils 2.13.90.0.4 and GCC (cross) 3.2 and was then trying to
configure and compile newlib 1.11.0
(anything wrong with using newlib here?. Mine is an embedded powerpc
-MPC8260- target system)
-----------------screen shot----
[root@linuxswan newlib-powerpc]# ../newlib-1.11.0/configure
--target=powerpc-linux
Configuring for a i686-pc-linux-gnu host.
*** This configuration is not supported in the following subdirectories:
target-newlib target-libgloss
(Any other directories should still work fine.)
Created "Makefile" in /root/anandapa/newlib-powerpc using "mt-frag"
./config.status is unchanged
[root@linuxswan newlib-powerpc]#
--------
I think the configuration step is incomplete here in setting up an cross
dev. environment to build applications for powerpc.
(library will not get compiled and installed with this config. I guess. Why
is it not taking directories recursive?)
I even, went on doing a 'make all install' and tried compiling a sample
application.
---------------------screen shot---
[root@linuxswan wd]# powerpc-linux-gcc -I /usr/include test.c
/usr/local/lib/gcc-lib/powerpc-linux/3.2/../../../../powerpc-linux/bin/ld:
cannot open crt1.o: No such file or directory
collect2: ld returned 1 exit status
-----------
Could some one correct me with the proper configuration steps required?
Thanks.
Rgds,
Ramanathan G A