This is the mail archive of the insight@sources.redhat.com mailing list for the Insight project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

RE: General question



We use the Motorola MPC561 on a bord that was develop by us.

The code I've written works. At least the initialisation code. It had
been tested with insight 5.0 and it worked fine. The problem is that
insight 5.0 clears the special purpose register 560 every time I do
single stepping. The register is not an chache register as insight
asumes. In the MPC561 it configurates the execption vector table which
is importent for interrupts. So we have to change the debugger.

To make it short:
We decited to use Insight 5.2 with OcdLibRemote under cygwin. As I said
in my last mail I can connect to the bord, set up the necessary
register, download the software and examin the memory. In my oppinion
the connetction between Insight and the MPC561 works. The problem is
that I can't to single stepping, even on assembly level. I set a
breakpoint on the first op-code of the initialisation code and hit
continue. But the breakpoint is never reached...

Any suggestions?

Regards,
Kai 
---
K. Hylla
Abt. NJT T3

ATLAS Elektronik GmbH
A BAE Systems Company
Sebaldsbruecker Heerstr. 235
D-28305 Bremen

Tel.: +49 421 457-3231
Fax : +49 421 457-1702 


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]