This is the mail archive of the
insight@sourceware.cygnus.com
mailing list for the Insight project.
Re: configuring for arm-elf-gdb
Louis LeGrand wrote:
>
> Andy and others,
>
> Thanks for responding to my question.
>
> Since my last message, I have sucessfuly built and installed arm-elf-gdb. It
> seems to work perfectly when run in the non-GUI mode (i.e. using the -nw
> option). However, when I run it in the GUI mode, the printf's output does not
> show up anywhere. I am using Redhat 6.1 not NT. Do you have this problem?
> The January 10, 2000 message from Kai Ruottu alludes to similar output issues.
> I am not sure if I am doing something wrong, or if not seeing output is a known
> "feature" of the code.
>
> Thanks again,
> L3
>
> Andy Hare wrote:
>
> > Hi
> >
> > I have been building Insight-GDB under cygnus b20.1 under NT. Below is
> > the following rules extracted from a makefile that I use to build all the
> > GNU toolset.
> >
> > .PHONY: config-insight
> > config-insight:
> > cd /c/cygnus/build/insight ; \
> > rm * -r ; \
> > /c/cygnus/GNU-Source-Code/insight/configure -v \
> > --prefix=/c/cygnus/xgcc-arm/insight \
> > --exec-prefix=/c/cygnus/xgcc-arm/insight \
> > --host=i586-cygwin32 --target=arm-elf >configure.out
> >
> > .PHONY: clean-insight
> > clean-insight:
> > cd /c/cygnus/build/insight ; \
> > make clean
> >
> > .PHONY: insight
> > insight:
> > cd /c/cygnus/build/insight ; \
> > make -w all install LIBGCC2_DEBUG_CFLAGS="-g1 -O1" LANGUAGES="c c++" >
> > make.out 2>&1
> >
> > These allow me to configure and build the Insight system, I have been using
> > it both in the simulator mode and to connect to the ATMEL EB01 eval. board.
> >
Do you have the "Console" window from Insight (not the one from where
you started gdb) open?
--
Fernando Nasser
Red Hat, Inc. - Toronto E-Mail: fnasser@redhat.com
2323 Yonge Street, Suite #300 Tel: 416-482-2661 ext. 311
Toronto, Ontario M4P 2C9 Fax: 416-482-6299