Re: Controlling gdb outside the terminal

[Brother Josef <thykeeper at nerdshack dot com>]

excellent, thank you. and yes actually I do need to look into MI  
mode, I'm new to GDB and just now considering it as the future in how  
I might be debugging. Could I run GDB without that error and continue  
to write and read from the program from within my Mac app?

Could anyone point me to any source code on pseudo-terminals or  
documents? I have been looking around today and I still can't get a  
clear picture of how such code would look providing I could even  
write it. ;) thanks again

On Sep 7, 2007, at 8:54 AM, Daniel Jacobowitz wrote:

> On Fri, Sep 07, 2007 at 08:12:55AM +0700, Brother Josef wrote:
> > I have a small amount of UNIX knowledge but have been using the  
> > gdb on the
> > command line and decided it would be possible to make a GUI to  
> > debug Pascal
> > under Mac OS X. With my limited knowledge I found that calls to  
> > popen and
> > reading the stream would work to with most commands but gdb  
> > complains "gdb)
> > Exception condition detected on fd 0 error detected on stdin". gpd  
> > runs a
> > seperate process so I think I need to be sending commands to that  
> > pid  but I
> > just can't figure it out. Could anyone point me to some  
> > informations? thanks
> > for your time.
>
> You need to read up on pseudo-terminals and job control for Unix
> systems.  However, I don't think you will need to if you use GDB
> in MI mode; that is highly recommended for front ends.
>
> --
> Daniel Jacobowitz
> CodeSourcery

Regards,
        Josef