This is the mail archive of the
gdb-patches@sourceware.org
mailing list for the GDB project.
[PATCH] wp-replication: Fix test case loop
- From: Andreas Arnez <arnez at linux dot vnet dot ibm dot com>
- To: gdb-patches at sourceware dot org, Luis Machado <lgustavo at codesourcery dot com>
- Date: Fri, 05 Jul 2013 18:10:07 +0200
- Subject: [PATCH] wp-replication: Fix test case loop
When executing wp-replication.exp on S/390, the loop that counts the
number of available hardware watchpoints does not terminate properly,
because *all* "watch" commands yield "hardware watchpoints".
Since the C source code is not prepared for more than NR_THREADS
hardware watchpoints anyhow, I suggest to add the appropriate exit
condition to the loop.
2013-07-05 Andreas Arnez <arnez@linux.vnet.ibm.com>
* gdb.threads/wp-replication.exp: Stop counting available hardware
watchpoints after NR_THREADS iterations.
diff --git a/gdb/testsuite/gdb.threads/wp-replication.exp b/gdb/testsuite/gdb.threads/wp-replication.exp
index 8927a43..af3594d 100644
--- a/gdb/testsuite/gdb.threads/wp-replication.exp
+++ b/gdb/testsuite/gdb.threads/wp-replication.exp
@@ -81,6 +81,10 @@ while { $done == 0 } {
gdb_test_multiple "continue" "watchpoint created successfully" {
-re ".*Breakpoint 2, empty_cycle \\(\\).*$gdb_prompt $" {
incr hwatch_count
+ if { $hwatch_count == $NR_THREADS } {
+ set done 1
+ break
+ }
}
-re ".*Could not insert hardware watchpoint.*$gdb_prompt $" {
set done 1