Re: [RFA] Darwin/x86 port (v4 - part 0/4)

[Tristan Gingold <gingold at adacore dot com>]

Thank you again for your comments.

> > I realized that we don't support configuring as x86_64-*-darwin*.
> > Maybe I should add it ?
>
> Probably, but I admit I don't know enough about the details.

As this cannot be reported by config.guess, I won't add it now.  Could  
be of course
revisited later.

> > + When set to a non zero value, enables debugging messages while  
> > gdb is
> > + reading Darwin object files.  The object and executable file format
> > + for Darwin is named mach-o.
>
> The last sentence above should probably be in parentheses, as that's a
> minor note.  Also, I would rearrange slightly:
>
>  (@dfn{Mach-o} is the file format used on Darwin for object and
>  executable files.)

Ok.

> > + @kindex set mach-exceptions
> > + On Darwin, faults are first reported as a mach exception and then  
> > as a
> > + signal.  Use this command to turn on trapping of mach exceptions in
> > + the inferior.  This might be seldom useful to better understand the
> > + cause of a fault. The default is off.
>
> So you are basically saying that mach exceptions are native Darwin
> exceptions, and they are then mapped to Posix signals?  At least that
> is what I understand from this explanation.

Yes.  I have used your reworded sentence.

> Also, please make sure you have 2 spaces after each period that ends a
> sentence.

Sure.

Tristan.