This is the mail archive of the
gdb-patches@sources.redhat.com
mailing list for the GDB project.
RFA: programs on stand-alone boards don't exit cleanly
- To: gdb-patches at sources dot redhat dot com
- Subject: RFA: programs on stand-alone boards don't exit cleanly
- From: Jim Blandy <jimb at zwingli dot cygnus dot com>
- Date: Wed, 5 Sep 2001 16:55:09 -0500 (EST)
2001-09-05 Jim Blandy <jimb@redhat.com>
* gdb.base/ending-run.exp: Don't expect to see the program end in
some orderly fashion when we're running on a real stand-alone
board.
Index: gdb/testsuite/gdb.base/ending-run.exp
===================================================================
RCS file: /cvs/cvsfiles/devo/gdb/testsuite/gdb.base/ending-run.exp,v
retrieving revision 1.11.66.1
diff -c -r1.11.66.1 ending-run.exp
*** gdb/testsuite/gdb.base/ending-run.exp 2001/06/15 16:03:34 1.11.66.1
--- gdb/testsuite/gdb.base/ending-run.exp 2001/09/05 21:51:52
***************
*** 164,170 ****
timeout { fail "hang or timeout on step at end 1" }
}
! if {![target_info exists use_cygmon] || ![target_info use_cygmon]} {
send_gdb "n\n"
gdb_expect {
-re "Program exited normally.*$gdb_prompt $" {
--- 164,175 ----
timeout { fail "hang or timeout on step at end 1" }
}
! # When we're talking to a program running on a real stand-alone board,
! # every BSP's exit function behaves differently, so there's no single
! # way to tell whether we've exited gracefully or not. So don't run
! # these tests when use_gdb_stub is set, or when we're running under Cygmon.
! if {! [target_info exists use_gdb_stub]
! && (! [target_info exists use_cygmon] || ! [target_info use_cygmon])} {
send_gdb "n\n"
gdb_expect {
-re "Program exited normally.*$gdb_prompt $" {