This is the mail archive of the
frysk-bugzilla@sourceware.org
mailing list for the frysk project.
[Bug general/5674] frysk does not handle "go" after a "run" command
- From: "rmoseley at redhat dot com" <sourceware-bugzilla at sourceware dot org>
- To: frysk-bugzilla at sourceware dot org
- Date: 30 Jan 2008 14:55:02 -0000
- Subject: [Bug general/5674] frysk does not handle "go" after a "run" command
- References: <20080125203404.5674.rmoseley@redhat.com>
- Reply-to: sourceware-bugzilla at sourceware dot org
------- Additional Comments From rmoseley at redhat dot com 2008-01-30 14:55 -------
Found problem and have fixed it, (not committed yet) for a single-threaded task.
There is still a problem with multi-threaded tasks, as when a thread is
spawned, it is not being set as "running" with the step engine.
--
What |Removed |Added
----------------------------------------------------------------------------
AssignedTo|frysk-bugzilla at sourceware|rmoseley at redhat dot com
|dot org |
Status|NEW |ASSIGNED
http://sourceware.org/bugzilla/show_bug.cgi?id=5674
------- You are receiving this mail because: -------
You are the assignee for the bug, or are watching the assignee.