This is the mail archive of the
ecos-patches@sourceware.org
mailing list for the eCos project.
[Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.
- From: bugzilla-daemon at bugs dot ecos dot sourceware dot org
- To: ecos-patches at ecos dot sourceware dot org
- Date: Tue, 09 Apr 2013 11:03:13 +0000
- Subject: [Bug 1001219] Ethernet driver for STM32 connectivity line with port on MMstm32f107 board.
- Auto-submitted: auto-generated
- References: <bug-1001219-104 at http dot bugs dot ecos dot sourceware dot org/>
Please do not reply to this email, use the link below.
http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001219
--- Comment #60 from Jerzy Dyrda <jerzdy@gmail.com> ---
Hello Ilija,
(In reply to comment #59)
> I was about to commit but in the last check I noticed something that needs
> explanation.
>
> The function hal_stm32x0_led(). I assume there is some conflict with
> ethernet. Please explain.
>
> There must be better solution that deletting 3 leds.
>
> 1. Make compilation conditional, so LEDS are in use when possible and
> ommitted otherwise.
>
> 2. Remove this function completely. or replace it with new. (I wouldn't
> reccommend this).
>
> If above assumption is not correct, there may be other solutions as well.
Sorry I omitted it during checking. This was used by me only for my debug
purpose. Development board, which I used, has only one LED.
Please skip this change it's absolutely not needed by driver.
Best regards,
jerzy
--
You are receiving this mail because:
You are on the CC list for the bug.