[ECOS] Re: eCOS Intel x86 Port

[prajeesh_77 at vsnl dot net]

Hi,
   Thank you for that information. I'm facing some problems with the eCOS configuration Tool version 2.11, I was previously using version 1.3.1. Should I go in for the latest version i.e 2.11. when I started using version 2.11 of the configuration tool it is asking for the path of the repository. There doesnt seem to be any info in the configtool-2.11-setup.exe downloaded from http://ecos.sourceware.org/ct2.html.

Regards
Prajeesh

----- Original Message -----
From: Gary Thomas <gary@mlbassoc.com>
Date: Monday, June 13, 2005 7:22 pm
Subject: Re: eCOS Intel x86 Port

> On Mon, 2005-06-13 at 15:40 +0500, prajeesh_77@vsnl.net wrote:
> > Hi,
> >    I'm doing an eCOS Port to Intel x86. Can you please tell me 
> > the changes that needs to be done in the HAL 
> Architecture/Variant/Platform 
> > to do the port(sample code should help). 
> >      Also can you just tell me the steps which are required to 
> install 
> > redboot on the PC before I get to install the ported eCOS code. 
> Any 
> > document on this would be exteremely helpful.
> 
> These questions are appropriate for the mailing list
>  ecos-discuss@sourceware.org
> Private support (at this email address) is only available with a
> support contract.
> 
> If you are using a "standard" PC, then all you need to do is write
> an eCos program, load and run it via RedBoot.  There are additional
> deployment methods as well - check the online documentation at
>  http://ecos.sourceware.org/docs-latest/
> 
> -- 
> ------------------------------------------------------------
> Gary Thomas                 |  Consulting for the
> MLB Associates              |    Embedded world
> ------------------------------------------------------------
> 
> 


-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss