This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Re: Write to diag serial without GDB
- From: Giuseppe Monteleone <info at ing-monteleone dot com>
- To: gary at mlbassoc dot com
- Cc: ecos-discuss at ecos dot sourceware dot org
- Date: Sun, 13 Feb 2005 18:03:53 +0100
- Subject: Re: [ECOS] Write to diag serial without GDB
I'm using ARM target. I got a version for Sharp LH754xx.
my problem are these
1) I see some char on diag interface, but are strange char. I suppose that
these char are the gdb protocol
2) is possible create a program that run only in ram without monitor
support?
Thanks for help
Giuseppe Monteleone
in that example i found module hal_diag.c and it's work because send back
something
Gary Thomas <gary@mlbassoc.com>
è stato scritto.
> On Sat, 2005-02-12 at 14:27 +0200, Giuseppe Monteleone wrote:
> > I'am looking for help to write a dummy program that write on serial
> > diag without gdb stub. I would like keep that program in ram.
>
> This would be the default behaviour for any RAM based eCos program.
>
> What platform/target are you using?
>
> --
> ------------------------------------------------------------
> Gary Thomas | Consulting for the
> MLB Associates | Embedded world
> ------------------------------------------------------------
>
>
> --
> Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
> and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
>
>
>
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss