[ECOS] Re: building redboot for pxa255

[Andrew Lunn <andrew at lunn dot ch>]

On Fri, Nov 26, 2004 at 02:45:24PM +0530, Manav Gautam wrote:
> >On Fri, Nov 26, 2004 at 11:07:22AM +0530, Manav Gautam wrote:
> > 
> >
> >>Hi All,
> >>         I have been trying to build redboot for the pxa255 but when i 
> >>do a
> >>/opt/ecos/ecos-2.0/tools/bin/ecosconfig new pxa2x0 redboot or
> >>/opt/ecos/ecos-2.0/tools/bin/ecosconfig new xscale redboot
> >>I end up getting a Unknown target pxa2x0  but the same works for grg etc
> >>Is the pxa not fully supported yet ? How do I got about the same. Any 
> >>suggestions would be great. I am using ecos version 2.0
> >>   
> >>
> >
> >grg is the name of development board, the Generic Residential
> >Gateway. pxa2x0 and xscale are not development boards, they are
> >processors families. What development board are you using? Search the
> >ecos.db or the hardware list on ecos.sourceware.org.
> >
> >       Andrew
> > 
> I have a custom board based on the pxa255. How can i go ahead doing the 
> same ?Which would be closest board which i can use as a template ? My 
> only requirement is the redboot bootloader cause we already have the BSP 
> up and running with blob bootloader.
> Andrew Lunn wrote:

In my experiance, its unusual for designers to make full custom
boards. They take the references design and modify it to there
needs. So talk to your hardware design people and ask them which
reference design they used as a basis for the hardware. See if eCos
supports that board and if so uses that as the basis.

        Andrew

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss