This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Installing RedBoot into AT91EB40 board (write into FLASH memory))
- To: ecos-discuss at sources dot redhat dot com
- Subject: [ECOS] Installing RedBoot into AT91EB40 board (write into FLASH memory))
- From: Gozman Florian Leonard <leonard at bluegem dot codec dot ro>
- Date: Fri, 03 Aug 2001 09:44:04 +0300
- Organization: bluegem
Hi!
Thanks for previous reply.
I have a problem when I try to write into FLASH. The messages which
occur into minicom are:
RedBoot>load -m y -b 0x02040000 // select redboot_ROMRAM.srec file and
send it
cs range: 0x02000000-0x0200c53c
xyzModem - CRC mode, 1098(SOH)/0(STX)/0(CAN) packets, 11 retries
RedBoot>fis write -f 0x01010000 -b 0x02040000 -l 0xe000
* CAUTION * about to program FLASH at 0x01010000..0x0101dfff from
0x02040000 - // block !!! if I pressed CR => RedBoot>
This message should be occur or not ?
After that, I press reset button on my board and nothing happens.
(Ofcourse the SW1 switch is "UPPER MEM").
Thanks!
Leonard
--
Leonard