This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
about redboot, gdb and embedded ice
- To: ecos-discuss at sources dot redhat dot com
- Subject: [ECOS] about redboot, gdb and embedded ice
- From: "A Roturier" <roturier at hotmail dot com>
- Date: Tue, 24 Jul 2001 13:15:13 +0000
hi list,
i make reboot image from arm aeb2 code and try to load it onto samsung
snds board(both with same samsung arm7 chips. its merely for testing purpose
only and i don't expect ecos' gonna run at all :-)). i have a few questions:
1, how do i change byte ordering from little endian to big endian?
2, after downloading redboot image onto the target with arm-elf-gdb, i can
only start single step execution by issuing 'nexti' in gdb console.
either
clicking on those execution 'buttons' in the main window or issuing
'next'
commman in console will make gdb 'hang'. this seems doesn't make sense.
3, after downloading image and before execution, what are the [correct]
initial
valuse of cpu registers? i observe that register values don't change a
bit
after i connect to target and before the execution starts(cpsr=0x60000010
in
this case. i.e., cpu is in user mode. and pc is not the specified ecos
entry
point). is this the right condition?
thanx for your attention.
kc
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp