This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
Re: Question about GNU Toolchain
- To: sun409 at pchome dot com dot tw
- Subject: Re: [ECOS] Question about GNU Toolchain
- From: Jonathan Larmour <jlarmour at redhat dot co dot uk>
- Date: Fri, 26 May 2000 13:08:35 +0100
- CC: ecos-discuss at sourceware dot cygnus dot com
- Organization: Red Hat UK Ltd.
- References: <20000526083558.8868.qmail@msc.tomail.com.tw>
sun409@pchome.com.tw wrote:
>
> I am going to port eCos to a MIPS R3000 based board.
>
> I've checked the documents for TX39 and VR4300. They all mentioned
> to do patches to binutils, gcc and gdb.
> If I use the new snapshots, that is, binutils-000521, egcs-20000501,
> and insight+dejagnu-20000520, do I need to apply these patches?
Nope. I imagine you should probably use the target "mips-elf", but it
depends on the specific chip (which I assume therefore isn't tx39).
Jifl
--
Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS Tel: +44 (1223) 728762
"Plan to be spontaneous tomorrow." || These opinions are all my own fault