This is the mail archive of the ecos-discuss@sourceware.cygnus.com mailing list for the eCos project.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
Hi all,
I'm trying to run the TCP/IP stack test programs on
an edb7209-2C.0 board.
I have disabled DHCP and enabled manual IP address
configuration.
And when I run ping_test I get: Init device 'edb7xxx'
cs8900 init CS8900 - type: 630E, rev: 800 CS8900 - status: D6 (no EEPROM present) Start PING test BOOTP[eth0] op: REPLY hw_type: Ethernet hw_addr: FF:FF:FF:FF:FF:FF client IP: 10.20.2.202 my IP: 10.20.2.202 server IP: 10.20.2.215 gateway IP: 10.20.2.215 options: subnet mask: 255.255.255.0 IP broadcast: 10.20.2.255 PING server 10.20.2.215 recvfrom: Operation timed out recvfrom: Operation timed out ....
So my board looks totaly outside the
network.
I take a look in the ethernet driver file
'if_edb7xxx.c' and my MAC address
should be "08:88:12:34:56:78", why does it show up as "FF:FF:FF:FF:FF:FF"
in the outgoing packet?
I can't figure out what I'm doing
wrong....
Is there any special point in the edb72xxx ethernet
configuration that I forget?
Thanks for your help.
Apologies in advance for what is, hopefully, a
stupid question...
Nicolas Gerber
|
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |