This is the mail archive of the
mailing list for the Cygwin project.
- To: Gabriele Dionisi <g dot dionisi at ic dot ac dot uk>
- Subject: Re: perlcc
- From: "Charles S. Wilson" <cwilson at ece dot gatech dot edu>
- Date: Thu, 14 Oct 1999 14:10:34 -0400
- CC: cygwin at sourceware dot cygnus dot com
- References: <38060B9A.5ABE0E2@ic.ac.uk>
As far as I am aware, perlcc was not truly enabled until some patches
were added post-version_61. (I'm surprised you're getting any response
at all with verion 5.005_03.) These patches are included in the
perl5.005_61 port on the cygutils website. So try that version;
hopefully it will work (without GDPro). What is GDPro anyway? Is it a
perl module or some separate program?
P.S. If it turns out that you DO need GDPro - of course there's a way
around the version mismatch problem. Rebuild GDPro from source using
your new 5.005_61 perl. :-)
Gabriele Dionisi wrote:
> I downloaded the binary version of perl
> (perl5.005_03-cygwinb20-dynamic-v1.4.tar.bz2) but when I run perlcc it
> complains because it can't find some GDPro perl library. I installed the
> last version of GDPro but now perlcc complains that the version of the
> GDPro library is too old.
> Does anyone know how to overcome this problem?
> Thank you very much,
> Want to unsubscribe from this list?
> Send a message to email@example.com
Want to unsubscribe from this list?
Send a message to firstname.lastname@example.org