This is the mail archive of the
cygwin-xfree@cygwin.com
mailing list for the Cygwin XFree86 project.
RE: Updated on sourceware: XFree86-xserv-4.2.0-7
- From: "ROTTENBERG,HAL (HP-USA,ex1)" <hal_rottenberg at hp dot com>
- To: "'cygwin-xfree at cygwin dot com'" <cygwin-xfree at cygwin dot com>
- Date: Mon, 24 Jun 2002 15:13:20 -0400
- Subject: RE: Updated on sourceware: XFree86-xserv-4.2.0-7
Since upgrading, Xterm will not open. Other X apps seem to work fine. I
will see a brief flicker of xterm trying to open (from my startwin.bat file)
then its gone. I'm using the wmaker WM. If I use the run command, either
nothing happens, or wmaker crashes. I've looked around a bit for any sort
of logs but haven't found anything so far.
The pertinent part of my startwin.bat file is very simple:
start /b XWin -unixkill
run xterm -sl 1000 -sb -rightbar -ms red -fg yellow -bg black -e
/usr/bin/bash
run wmaker
What did I do wrong??
Hal Rottenberg | Email: hal_rottenberg@hp.com
Technical Support Engineer | Jabber: hal_rottenberg@jabber.hp.com
http://www.hp.com/security | Phone: +1-404-774-4041
HEWLETT-PACKARD