This is the mail archive of the
cygwin-xfree@cygwin.com
mailing list for the Cygwin XFree86 project.
Re: Esound update [need an autoconf/automake wizard]
- To: "Harold Hunt" <huntharo at msu dot edu>,"cygx" <cygwin-xfree at cygwin dot com>
- Subject: Re: Esound update [need an autoconf/automake wizard]
- From: "Robert Collins" <robert dot collins at itdomain dot com dot au>
- Date: Fri, 26 Oct 2001 14:40:46 +1000
- References: <NHEELHJHHFKPMAEAFMFCKEEFCKAA.huntharo@msu.edu>
Ok, I'll dig in this weekend. What version of esound did you grab? (to
avoid confusion).
Rob
----- Original Message -----
From: "Harold Hunt" <huntharo@msu.edu>
To: "Robert Collins" <robert.collins@itdomain.com.au>; "cygx"
<cygwin-xfree@cygwin.com>
Sent: Friday, October 26, 2001 2:36 PM
Subject: RE: Esound update [need an autoconf/automake wizard]
> Robert,
>
> > Just copy in config.guess from a newer project and you should be
fine.
> > Can you try that and if it works, thats all the patch needed for the
> > esound maintainers :}. I'll happily look harder at it if replacing
> > config.guess doesn't work.
>
> Copying a new config.guess results in precisely the same warnings and
> errors.
>
> Copying in config.guess and config.sub fixes the unknown platform
warnings,
> but it results in a new, seemingly unrelated error:
>
> checking for ld used by GCC... -e: not found
> no
> configure: error: no acceptable ld found in $PATH
>
> I couldn't figure out what was going on...
>
> Harold
>
>