This is the mail archive of the crossgcc@sources.redhat.com mailing list for the crossgcc project.
See the CrossGCC FAQ for lots more information.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
I have a project that I am trying to convert over from the Microtec tools to GNU. I've got almost everything working, but on one assembler file I am getting a strange error. The GNU tools (binutils incl. as and gcc) are configured for m68k-coff and running on Solaris. as version is 2.10.1 I am compiling a assembler source for a Coldfire 5307 target. The source assembles properly on the Microtec tools and I can get the results running properly on the target hardware. But for some reason GNU as tells me that some of the instructions are invalid for the target. command line: m68k-coff-as -M -m5307 file.s (I tried -m5200 first, as -m5307 was not mentioned in the manual, but same errors. -M is in there to be in the MRI compatibility mode, very necessary unless I want to get an error on almost every line) for 4 lines in a 600+ line file I get the following error: 'Error: invalid instruction for this architecture; needs 68000 or higher' The instructions in question: 'cmp d3,d1' 'andi #inton,d0' 'adda #16,a0' 'andi #$7FF,d0' These instructions ARE valid for the 5307 (I checked the manual). Anyone have some ideas? Thanks in advance, - Steve ------ Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/ Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |