This is the mail archive of the crossgcc@sourceware.cygnus.com mailing list for the crossgcc project.
See the CrossGCC FAQ for lots more infromation.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
Yes I am but in the AEB user guide the arm-coff is used. That confused me a bit but now I know I don't have to recompile:) /Andreas -----Original Message----- From: Jonathan Larmour [mailto:jlarmour@redhat.co.uk] Sent: den 4 juli 2000 19:37 To: Karlsson Andreas Cc: aeb@arm.com; crossgcc@sourceware.cygnus.com Subject: Re: Beginners Question Andreas.Karlsson@combitechsystems.com wrote: > > I will do development on the AEB-evaluation board. > I will run eCos and the GNU toolkit. > My question is; should I configure the tools with arm-elf or arm-coff? Absolutely arm-elf. I thought from your earlier posts that you were already following the installation instructions at http://sourceware.cygnus.com/ecos ? Jifl -- Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS Tel: +44 (1223) 728762 "Plan to be spontaneous tomorrow." || These opinions are all my own fault ------ Want more information? See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/ Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |