This is the mail archive of the
crossgcc@cygnus.com
mailing list for the crossgcc project.
Re: FYI: gdb-4.18 + target ARM (or Thumb) used with Angel + DebianGNU/Linux
- To: crossgcc@cygnus.com, christian.ericsson@bigfoot.com
- Subject: Re: FYI: gdb-4.18 + target ARM (or Thumb) used with Angel + DebianGNU/Linux
- From: Jonathan Larmour <jlarmour@cygnus.co.uk>
- Date: Wed, 28 Jul 1999 02:53:19 +0000
- Organization: Cygnus Solutions
- References: <4.1.19990728014612.00a03e10@mail.dataservice.se>
- Reply-To: crossgcc@cygnus.com
Christian Ericsson wrote:
>
> FYI:
>
> gdb-4.18 will not work with the configuration above, if not
> patched!
>
> I have been trying to get target debugging to work with
> Atmel evaluation board featuring the ARM7TDMI processor.
> The command "target rdi /dev/ttyS0" didn't work in gdb-4.18.
>
> The problem was that normal Linux systems use /dev/cua0
> as the first serial port, but Debian GNU/Linux 2.1 (which I use)
> use /dev/ttyS0 instead.
Well spotted. Actually, /dev/cua is deprecated on all modern linux systems
now.
It turns out after a quick look that the GDB team has already found and
fixed this problem. You can get a fixed snapshot from
http://sourceware.cygnus.com/gdb/. It's fixed in the gdb-19990719 snapshot
or later.
Jifl
--
Cygnus Solutions, 35 Cambridge Place, Cambridge, UK. Tel: +44 (1223) 728762
"I used to have an open mind but || Get yer free open source RTOS's here...
my brains kept falling out." || http://sourceware.cygnus.com/ecos
Help fight spam! http://spam.abuse.net/ These opinions are all my own fault
_______________________________________________
New CrossGCC FAQ: http://www.objsw.com/CrossGCC
_______________________________________________
To remove yourself from the crossgcc list, send
mail to crossgcc-request@cygnus.com with the
text 'unsubscribe' (without the quotes) in the
body of the message.