ld/x86-64: adjust pr14207 test expectations

The original test output expectations cause it to fail when configure
determines enable_initfini_array=no (which was observed on a cross
build on an old 32-bit host, pointing out that taking into account host
properties in such a case is bogus anyway).

--- 2015-01-08/ld/testsuite/ld-x86-64/pr14207.d	2014-02-20 15:36:37.000000000 +0100
+++ 2015-01-08/ld/testsuite/ld-x86-64/pr14207.d	2015-01-08 12:52:56.000000000 +0100
@@ -11,14 +11,14 @@ There are 4 program headers, starting at
 Program Headers:
   Type           Offset   VirtAddr           PhysAddr           FileSiz  MemSiz   Flg Align
   LOAD           0x000000 0x0000000000000000 0x0000000000000000 0x0001e0 0x0001e0 R   0x200000
-  LOAD           0x000b48 0x0000000000200b48 0x0000000000200b48 0x0004b0 0x000cf8 RW  0x200000
-  DYNAMIC        0x000b90 0x0000000000200b90 0x0000000000200b90 0x0001c0 0x0001c0 RW  0x8
-  GNU_RELRO      0x000b48 0x0000000000200b48 0x0000000000200b48 0x0004b8 0x0004b8 R   0x1
+  LOAD           0x000b.8 0x0000000000200b.8 0x0000000000200b.8 0x0004.0 0x000c.8 RW  0x200000
+  DYNAMIC        0x000b.0 0x0000000000200b.0 0x0000000000200b.0 0x0001.0 0x0001.0 RW  0x8
+  GNU_RELRO      0x000b.8 0x0000000000200b.8 0x0000000000200b.8 0x0004.8 0x0004.8 R   0x1
 
  Section to Segment mapping:
   Segment Sections...
-   00     .hash .dynsym .dynstr 
-   01     .init_array .fini_array .jcr .data.rel.ro .dynamic .got .bss 
-   02     .dynamic 
-   03     .init_array .fini_array .jcr .data.rel.ro .dynamic .got 
+   00     \.hash \.dynsym \.dynstr 
+   01     \.(init_array|ctors) \.(fini_array|dtors) \.jcr \.data\.rel\.ro \.dynamic \.got .bss 
+   02     \.dynamic 
+   03     \.(init_array|ctors) \.(fini_array|dtors) \.jcr \.data\.rel\.ro \.dynamic \.got 
 #pass