This is the mail archive of the mailing list for the binutils project.

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

Re: [RFC,GAS]Propose to emit the attribute section after relaxation

On Thu, Sep 18, 2014 at 04:42:45PM +0800, Terry Guo wrote:
> On Thu, Sep 18, 2014 at 4:15 PM, Alan Modra <> wrote:
> > That sounds reasonable.  What you've done in the patch though is put
> > the create_obj_attrs_section call later than relax_seg, after
> > size_seg.  Is there a reason you can't call create_obj_attrs_section
> > immediately after the relax_seg loop?
> There are two reasons for this. [snip]

The only real reason to put create_obj_attrs_section immediately after
the relax_seg loop is if at some stage someone wants to put symbols in
the obj_attrs section and then refer to them in expressions from
another section.  For example, someone might want obj_attr_start and
obj_attr_end symbols, and use them to put the size of the obj_attr
section into a data word.  Doing that sort of thing would mean
integrating create_obj_attrs_section into the relax_seg loop, a task
made a little easier if create_obj_attrs_section was just after the
loop.  I think that is unlikely, so the patch is OK as is.

Alan Modra
Australia Development Lab, IBM

Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]